Buffalo Wild Wings
Buffalo Wild Wings
Buffalo Wild Wings
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Buffalo</strong> <strong>Wild</strong> <strong>Wings</strong><br />
4. Roofing Felt: Install felt underlayment over insulation board under sheet metal roofing.<br />
Use adhesive for temporary anchorage to minimize use of mechanical fasteners under<br />
sheet metal roofing. Apply over entire roof surface, in shingle fashion to shed water, with<br />
lapped joints of not less than 2 inches.<br />
5. Install roof flashing, trim and moldings securely to substrate. Seal joints and laps in<br />
components for water tight seal. Install metal flashing to lap over sheet metal roofing to<br />
allow moisture to run over and off the material.<br />
6. Install roof panels securely in place in strict accordance with manufacturer’s instructions<br />
with provisions for thermal and structural movement.<br />
C. Standing Seam Canopy End Panel System:<br />
1. Install roofing system clips and bearing plates to plywood substrate with approved<br />
fasteners in accordance with manufacturer’s instructions.<br />
2. Roofing Felt: Install felt underlayment over plywood substrate under sheet metal roofing.<br />
Use adhesive for temporary anchorage to minimize use of mechanical fasteners under<br />
sheet metal roofing. Apply over entire vertical surface, in shingle fashion to shed water,<br />
with lapped joints of not less than 2 inches.<br />
3. Install roof flashing, trim and moldings securely to substrate. Seal joints and laps in<br />
components for water tight seal. Install metal flashing to lap over sheet metal roofing to<br />
allow moisture to run over and off the material.<br />
4. Install roof panels securely in place in strict accordance with manufacturer’s instructions<br />
with provisions for thermal and structural movement.<br />
3.04 CLEANING AND PROTECTION<br />
A. Clean exposed sheet metal work at completion of installation. Remove grease and oil films,<br />
excess joint sealer, handling marks, and debris from installation, leaving the work clean and<br />
unmarked, free from dents, creases, waves, scratch marks, or other damage to the finish.<br />
B. Do not permit storage of materials or roof traffic on installed roof panels. Provide temporary<br />
walkways or planks as necessary to avoid damage to completed work. Protect roofing until<br />
completion of project.<br />
C. Touch-up, repair, or replace damaged roof panels or accessories before date of Substantial<br />
Completion.<br />
END OF SECTION<br />
04-27-11 PREFORMED METAL ROOF PANELS<br />
07411 -4
Change language