Buffalo Wild Wings

Buffalo Wild Wings
B. Water-Resistive Coatings: EIFS manufacturer's standard formulation and accessories for use
as water/weather-resistive barriers, compatible with substrate, and complying with physical and
performance criteria of ICC-ES AC212.
1. Sheathing Joint Tape: Type recommended by EIFS manufacturer for sealing joints
between and penetrations through sheathing.
C. Drainage Strip/Track: Manufacturer’s standard PVC track or strip to provide drainage of system.
Coordinate component selected with specific details indicated on Drawings.
D. Insulation Adhesive: EIFS manufacturer's standard formulation designed for indicated use,
compatible with substrate, and complying with the following:
1. Factory-blended dry formulation of portland cement, dry polymer admixture, and fillers
specified for base coat.
E. Insulation Board: Molded, rigid cellular polystyrene insulation board complying with
ASTM C 578, Type I; EIFS manufacturer's requirements; and EIMA's "EIMA Guideline
Specification for Expanded Polystyrene (EPS) Insulation Board" for most stringent requirements
for material performance and qualities of insulation, including dimensions and permissible
variations, and the following:
1. Aging: Before cutting and shipping, age insulation in block form by air drying for not less
than six weeks or by another method approved by EIMA that produces equivalent results.
2. Flame-Spread and Smoke-Developed Indexes: 25 and 450 or less, respectively, per
ASTM E 84.
3. Dimensions: Provide insulation boards in thickness indicated, but not more than 4 inches
thick or less than thickness allowed by ASTM C 1397.
4. Foam Shapes: Provide with profiles and dimensions indicated on Drawings.
F. Reinforcing Mesh: Balanced, alkali-resistant, open-weave, glass-fiber mesh treated for
compatibility with other EIFS materials, made from continuous multi-end strands with retained
mesh tensile strength of not less than 120 lbf/in. per EIMA 105.01; complying with ASTM D 578
and the following requirements for minimum weight:
1. Standard-Impact Reinforcing Mesh: Not less than 4.0 oz./sq. yd.
2. High-Impact Reinforcing Mesh: Not less than 15 oz./sq. yd.
3. Detail Reinforcing Mesh: Not less than 4.0 oz./sq. yd.
4. Corner Reinforcing Mesh: Not less than 7.2 oz./sq. yd.
G. Base Coat Materials: EIFS manufacturer's standard mixture complying with the following:
1. Formulation of portland cement complying with ASTM C 150, Type I, white or natural color;
and manufacturer's standard 100% acrylic adhesive designed for use with portland
cement.
2. Materials to be shipped pre-measured for job-site mixing.
H. Tinted Base-Coat Primer (provide if required by manufacturer): EIFS manufacturer's standard
100% acrylic primer for preparing base-coat surface for application of finish coat.
1. Note: Primer to be tinted to closely match Finish Coat including custom colors.
I. Finish-Coat Materials: EIFS manufacturer's standard 100% acrylic-based coating complying
with the following:
1. Factory-mixed formulation of polymer-emulsion binder, colorfast mineral pigments, sound
stone particles, and fillers.
2. Refer to EIFS Schedule at end of this Section for finish coat color and texture.
J. Mildew Resistant Finish Additive: EIFS manufacturer's standard mildew resistance additive for
the EIFS system finish coat.
Dryvit: “PMR Finish”.
Comparable products from other specified EIFS manufacturers.
K. Water: Potable.
12/28/10 EXTERIOR INSULATION AND FINISH SYSTEM
07240 -4