Buffalo Wild Wings

Buffalo Wild Wings
3.02 DELIVERY AND STORAGE
A. Deliver in original unopened packages and store in enclosed shelter; protect from damage and
exposure to direct sunlight. Remove damaged or deteriorated materials from premises.
3.03 BATT INSTALLATION
A. Install insulation in accordance with manufacturer's instructions.
B. Trim insulation neatly to fit spaces. Insulate miscellaneous gaps and voids.
C. Fit insulation tightly in cavities and tightly to exterior side of mechanical and electrical services
within the plane of the insulation.
3.04 BOARD INSTALLATION
A. Insulate interior face of exterior concrete foundation, including returns under floor slab as
indicated on the drawings. Provide complete insulation membrane around entire building
whether specifically indicated or not.
B. Mechanically fasten insulation boards to substrate at NRCA, UL or FM required spacing,
whichever is more stringent.
C. Apply insulation boards parallel to roof perimeter edges.
D. Lay second layer of insulation with joints staggered from first layer
E. Lay insulation boards with edges in moderate contact without forcing. Cut insulation to fit neatly
to perimeter blocking and around penetrations through roof.
F. Apply no more insulation than can be sealed with membrane in same day.
G. Keep insulation a minimum of 3 inches from heat emitting devices, and a minimum 2 inches
from sidewalls.
H. Install after building embankment and granular cushion have been completed and vapor
retarder is in place. Lay insulation in place, edges closely pressed together, against inside face
of foundation beam excavation; returned under floor slab as shown on the drawings. Pour
concrete to cover insulation.
3.05 PROTECTION OF FINISHED WORK
A. Do not permit installed insulation to be damaged prior to its concealment.
3.06 CLEAN-UP
A. Upon completion of work of this section, remove related debris from premises.
END OF SECTION
03/09/10 BOARD AND BATT INSULATION
07212 -3