Buffalo Wild Wings

Buffalo Wild Wings
SECTION 07212 - BOARD AND BATT INSULATION
PART 1 GENERAL
1.01 SECTION INCLUDES
A. Batt insulation in exterior wall construction.
B. Batt insulation for filling perimeter window and door shim spaces, crevices in exterior wall and
roof, and roof and miscellaneous stud spaces.
C. Batt insulation for acoustic insulation in interior partitions.
D. Board Insulation at roof.
E. Board Insulation for exterior foundations.
1.02 RELATED SECTIONS
A. Section 05400 - Cold Formed Metal Framing: Supporting construction for batt insulation.
B. Section 06100 – Rough Carpentry.
C. Section 07260 – Air and Vapor Barriers.
D. Section 07535 - Mechanically Attached Membrane Roofing.
1.03 REFERENCES
A. ASTM C 665 - Standard Specification for Mineral-Fiber Blanket Thermal Insulation for Light
Frame Construction and Manufactured Housing.
B. ASTM E 136 - Standard Test Method for Behavior of Materials in a Vertical Tube Furnace At
750 Degrees C.
C. ASTM C 578 – Standard Specification for Rigid, Cellular Polystyrene Thermal Insulation.
D. ASTM C 1289 - Standard Specification for Faced Rigid Cellular Polyisocyanurate Thermal
Insulation Board.
E. ASTM D 1621 - Standard Test Method for Compressive Properties Of Rigid Cellular Plastics.
F. ASTM D 1622 - Standard Test Method for Apparent Density of Rigid Cellular Plastics.
G. ASTM E 84 - Standard Test Method for Surface Burning Characteristics of Building Materials.
1.04 QUALITY ASSURANCE
A. Source Limitations: Obtain each type of building insulation through one source from a single
manufacturer.
B. Verify that polyisocyanurate roof insulation is acceptable with roof membrane manufacturer.
Refer to Section 07535.
1.05 DELIVERY, STORAGE, AND HANDLING
A. Protect insulation materials from physical damage and from deterioration by moisture, soiling,
and other sources. Store inside and in a dry location. Comply with manufacturer's written
instructions for handling, storing, and protecting during installation.
03/09/10 BOARD AND BATT INSULATION
07212 -1