reprap-granule-extruder-tudelft1

Recommendations

Info

Delft University of Technology Faculty of Industrial Design Engineering Department of Design Engineering Prototyping Lab (IO3028): G.B. Braanker (1365045) J.E.P. Duwel (1363425) J.J. Flohil (1285653) G.E. Tokaya (1309528) Contact: http://<strong>reprap</strong>delft.wordpress.com/ j.e.p.duwel@student.tudelft.nl
Page 1 and 2: Developing a plastics recycling add
Page 3 and 4: Table of Contents 1. Introduction 5
Page 5 and 6: 1 İntroduction The RepRap is a 3D
Page 7 and 8: 2 | The RepRap project Fused deposi
Page 9 and 10: 3 | From product to granule Possibl
Page 11 and 12: 3 | From product to granule Figure
Page 13 and 14: 3 | From product to granule As for
Page 15 and 16: 4 | From granule to extrusion decre
Page 17 and 18: 4 | From granule to extrusion threa
Page 19 and 20: 4 | From granule to extrusion screw
Page 21 and 22: 4 | From granule to extrusion Figur
Page 23 and 24: 5 Ȧdapting the prototype to the Re
Page 25 and 26: 6 Ċonclusion and discussion The ma
Page 27 and 28: 7 Ṙecommendations for further dev
Page 29 and 30: 8 Ṙeferences 1 - Bowyer, A. 1992.
Page 31 and 32: Appendix A Blender granule tests 1.
Page 33 and 34: A | Blender granule tests 5. Blendi
Page 35 and 36: - Granule still bounces up without
Page 37 and 38: A | Blender granule tests 13. Blend
Page 39 and 40: Appendix B. Technical drawings of t
Page 41 and 42: 50 5 5 10 25 50 50 10 R8 5 25 1 10
Page 43 and 44: M16 20 25 14 2 30° 7 nozzle benami
Page 45: Appendix C. Extrusion screw manufac

reprap-granule-extruder-tudelft1

Create successful ePaper yourself

Delete template?

Save as template?