Unicenter CA-Scheduler Job Management for VSE User Guide

2.2 Maintaining Stations
SCHD-WD STATION DIRECTORY CA-SCHEDULER
===> _ MASTER - WR
CONNECT : 4
ID STNAME TIME-ZN DESCRIPTION
2 KEYPUNCH WHERE INPUT DATA IS KEYPUNCHED
21 KEYPUNCH
27 INITIALS
39 STAGING WHERE JCL CHANGES BEFORE JOBS RUN
4 CPU WHERE THE JOBS ARE RUN
6 OUTPUT WHERE OUTPUT IS DISTRIBUTED FROM
END OF DIRECTORY LIST
PF1=HELP
The stations you see listed are different than those shown here. However, you
should be able to spot the station you defined.
Select that station so you can alter its values. Start by tabbing down to that
line. Then type A and press Enter.
If your authority level permits you to alter station records, Unicenter
CA-Scheduler displays your station record so you can type in new values. Try
adding a station description such as you see following:
SCHD-WU STATION ALTER CA-SCHEDULER
===> MASTER - WR
CONNECT : 4
STATION ID : 27
STATION NAME
: initials
TIME ZONE :
STATION TITLE : your userid
STATION DESCRIPTION : This is a test record
PF1=HELP
2.2.3 Deleting Workstations
Press Enter to save your changes or press Clear to cancel them. When
Unicenter CA-Scheduler has changed your station record, it confirms the
correction by displaying the message:
CACU18I STATION 27 INITIALS HAS BEEN ALTERED
Then press Clear until you return to the Station Maintenance menu.
Deleting records is similar to altering them: Unicenter CA-Scheduler gives you
two methods to choose from. Which method you use depends on whether you
know what station number to delete.
To delete a specific station number, begin by checking which option on the
Station Maintenance menu allows you to delete an existing record.
Chapter 2. Startup Tasks 2-13