Unicenter CA-Scheduler Job Management for VSE User Guide

4.4 Handling Predecessor Conditions
To unpost a predecessor condition, go to the Online Monitoring panel and
enter one of the following:
Enter
5,DSN N=dsname
5,SSCD N=sname
5,SJOB N=jname
-5,SCD N=sname
-5,JOB N=jname
-5,VSE N=jname
If The Predecessor You Are Unposting Is The
Close of a data set
Start of a
-schedule
-job
End of a
-schedule
-job
-nonscheduled DOS job
Type the name of a data set, schedule or job following the predecessor
keywords listed in the chart preceding. If the predecessor is a job, also give the
schedule name, job number, and station number. If you cannot fit all of the
information on the panel, end with a comma. This will give you a continuation
panel. Once you have unposted a predecessor condition manually, Unicenter
CA-Scheduler reacts as if the event never occurred. This affects Unicenter
CA-Scheduler totally, so the impact is not limited to just today's workload or
just this CPU. See the description of the UNPOST command in the Unicenter
CA-Scheduler Reference Guide Part 1.
4-26 Unicenter CA-Scheduler User Guide