Unicenter CA-Scheduler Job Management for VSE User Guide

4.2 Displaying Status
WAITING FOR START TIME
The job or schedule is waiting for its early start time. It will
not be available for processing until then unless it is forced
using the FORCE command.
WAITING NON-CPU START
This is a non-CPU job that was defined as AUTO START=NO.
It is now available and must be manually started using the
online START command.
WAITING PRE-CPU JOB
All of this job's predecessors have been satisfied except the
same job at a pre-CPU station. It will not be submitted at the
CPU station until it has ended at all of the pre-CPU stations in
its path.
WAITING USER SUBMIT
Unicenter CA-Scheduler tried to release the JCL for a job and
failed because the JCL has not yet been manually submitted to
the RDR queue. The job must be manually submitted with
DISP=H specified on the JECL job card. Unicenter
CA-Scheduler will try at regular intervals to release the job.
This status will only be seen for jobs defined with LIBTYPE =
RDRQ.
4-22 Unicenter CA-Scheduler User Guide