Unicenter CA-Scheduler Job Management for VSE User Guide

4.2 Displaying Status
If the schedule is still waiting to start, the REMAINING TIME field shows the
average run time of the schedule in hours and minutes followed by a '+' to
indicate the amount of time the schedule will probably take to complete. If the
schedule has already started, however, this field is calculated by subtracting
the elapsed time from the average time. A '-' indicates that the schedule has
taken longer than average. The AVERAGE RUN TIME shows the schedule's
average execution time based on Unicenter CA-Scheduler's history data.
Another very important column in this panel is RERUN. It indicates that this
schedule has been carried over as backlog from a previous day and will run
again when this schedule ends.
The panel preceding shows CASCHD3 was supposed to run yesterday (11/5).
That schedule started 18 minutes ago (3.32 - 3.14) and still has over three hours
to run (3.14). The RERUN field indicates that when CASCHD3's jobs from
yesterday are done, CASCHD3 will run again with today's jobs.
4.2.5 Examples
These examples combine various parameters to illustrate some of the options
available with the Online Status panel.
To Display
PAYJ jobs in all
schedules that are
waiting for
predecessors
Start and end times of
all jobs run on the
computer
Late jobs in order of
priority
All jobs in the
PAYROLL schedule
that run on the
computer
All jobs scheduled at
the data entry station
that are waiting to be
started in order of
priority
Move The Cursor To And
Type
WAIT-PREDECESSOR
COMPLETED
LATE
ALL
SUBMITTED
J=PAYJ*
D=T,ST=40
OR=P
S=PAYROLL,
ST=40
ST=20,OR=P
4-16 Unicenter CA-Scheduler User Guide