Unicenter CA-Scheduler Job Management for VSE User Guide

4.2 Displaying Status
SCHD-CP SCHEDULER COMMAND PROCESSOR CA-SCHEDULER
===> MASTER - WR
CONNECT : 4
SCHEDULE JOB SYS AVG START END COMP
NAME NAME JNO ST ID TIME TIME TIME S T A T U S CODE
ABCXY 1 .19 16.5 17.3
ABC 1 39 1 . 5 16.5 16.17 ENDED
1 39 1 .5 16.44 16.45 ENDED
1 39 1 .5 16.55 16.58 ENDED
ABC 1 4 1 .7 16.17 16.2 ABENDED 14
1 4 1 .7 16.46 16.5 ABENDED 18
1 4 1 .7 17. 17.2 ENDED
XYZ 1 4 1 .7 16.21 16.3 FAILED 8
1 4 1 .7 16.5 16.54 FAILED 16
1 4 1 .7 17.21 17.3 ENDED
PRESS ENTER FOR NEXT PAGE
PF1=HELP
This display also lists jobs within schedules.
The primary difference between this and the default display is that the History
display depicted preceding contains the average run time and the completion
code of the job. The average time of a job is based on its history and you can
use it to immediately determine if something is out of line. The status code
appears, but does not contain the same amount of information as the default
status display.
4.2.4.4 Sample Schedule Summary Status Display
By specifying
D=S, you get the Schedule Summary status display. This panel shows output
that could result from typing just
D=S in the ACTIVE field on the Online Status panel. Average time is shown
in DD/hh.mm format.
SCHD-CP SCHEDULER COMMAND PROCESSOR CA-SCHEDULER
===> MASTER - WR
CONNECT : 4
SCHEDULE S T A R T E N D DEADLINE REMAINING AVERAGE RER
NAME DATE TIME DATE TIME DATE TIME TIME RUN TIME UN
CASCHD1 11/6 11.2 11/6 19.22 11/6 2. 8.12
CASHCD2 11/6 14.48 11/6 15.35 11/6 16.3 .44
CASCHD3 11/6 19.15 11/6 . 11/5 23.15 3.14 3.32 Y
PRESS ENTER FOR NEXT PAGE
PF1=HELP
This display just summarizes schedules. Along with the date and time at
which schedules started and finished, you can also see when they were due to
finish.
Chapter 4. Online Monitoring 4-15