Unicenter CA-Scheduler Job Management for VSE User Guide

4.1 Online Monitoring Panel
The following table describes what you can do with the various fields on this
panel.
By Selecting
ONLINE STATUS
QUERY MESSAGES
SEND MESSAGE
POST DEPENDENCY
UNPOST DEPENDENCY
SET/DISP GLOBALS
DISPLAY
JOB COMMANDS
SCHEDULE COMMANDS
You Can
Display schedule status at the stations
you are authorized to connect to.
Display messages that have been sent to
your userid.
Cause a message to be sent to other
userids.
Satisfy a predecessor condition so that a
waiting job or schedule can be
processed.
Inhibit a predecessor condition so that a
waiting job or schedule cannot be
processed.
Display global parameters or cause
predecessor conditions to be satisfied by
supplying a value for GBLxnn.
Display a variety of information
including:
■
■
■
Date and autoscan information
Data set mask names (CAIJ$DSN
macros)
Network information
Control jobs by issuing control
commands.
Control schedules by issuing control
commands.
For example, you can send messages, post predecessors, and set global
parameters without leaving the Online Monitoring panel. All of these facilities
are described in detail later in this chapter.
To enter a command, you must enter the number that appears next to it on the
command line (===>). You may enter optional keywords by separating them
from the number and from each other with commas. This method of issuing
commands differs from what you have seen elsewhere in Unicenter
CA-Scheduler and is discussed in detail (including examples) in the topics that
follow.
Chapter 4. Online Monitoring 4-3