Unicenter CA-Scheduler Job Management for VSE User Guide

3.9 Defining Jobs
Use a 24-hour clock to specify MUST START BY TIME and COMPLETION
DEADLINE TIME. The chart following shows that you can omit leading zeros
and you can extend the 24-hour clock by days.
A Value Of
Uses This
Notation
And Means Late Messages Will Be
Issued
930 hhmm After 9:30 a.m. that day
1400 hhmm After 2 p.m. that day
11800 ddhhmm After 6 p.m. the next autoscan day
Warning messages are sent to the operator if OPERATOR was specified on the
MSG installation option. However, you can route those messages to any other
userid by specifying that userid as the value for the MSG installation option. If
you want messages sent to other userids, you can specify them in the schedule
and job message records (SMR and JMR).
You can specify MAILBOX as one of the userids, and the messages will be sent
to a common mailbox where they can be viewed using the Reporting Facility
panel.
3.9.3.13 How Do You Create Optional Job Records?
The RECS fields at the bottom of job panels fulfill two functions:
■
■
The values displayed show whether each type of record already exists for
this job. N means that type of record hasn't been defined yet.
The fields allow you to input commands that will branch to these records.
The chart following shows what these commands can do.
If The Current Value Is Enter To
N C Create that record
Y
A
D
Alter that record
Display that record
The chart following explains the purpose of each record type.
If You Want To Select This Record By Typing After
Define
■ The days on which the
job is selected
■ Predecessor conditions
that must be satisfied
job criteria
JCR:
3-74 Unicenter CA-Scheduler User Guide