CA Dynam for VSE User Guide

ASCII tape
DTF restriction, 6-3
support, 2-73
AS-OF-DATE, 8-55
AS-OF-DATE retention, 2-9
ASSGN function (TDYNASN), 2-7, 3-2, 3-3
Assigning
logical unit, 3-3
mode in TLBL, 2-46
scratch tapes, 2-16
tape files to physical devices, 2-12, 2-13
volume serial numbers, 2-6
Asterisks in AMF DSN, 2-69
Audit data set
also see AUDTUTIL, 12-1
backup tapes, 12-4, 12-6
logging, 12-2
recovering the Catalog, 12-4
reporting commands, 12-11
Audit data set, purpose of, 2-1
Auditing program (AUDTUTIL), 12-1
AUDTUTIL utility program
Catalog recovery steps, 12-4
commands
maintenance, 12-5
reporting, 12-11
control statement syntax, 12-5
overview, 12-1
reporting
commands, 12-11, 12-15
predefined reports, 12-12
report fields, 12-29
user-defined reports, 12-14
Automatic
cataloging, 2-60
multifile data sets
as input, 2-71
defining, 2-69
renaming, 2-72
reporting TAPE ERRS, 3-43
scratching names, 2-71
volume switching, 2-70
Retry Facility, 2-29
Secondary Allocation (ASA), 4-5, 4-17
volume assignment/recognition, 4-24
Auxiliary messages, 7-26
AVR
activating, 2-12
defining disk volumes, 4-32
disk files, 4-24
finding scratch tapes during, 2-52
functioning of, 2-29, 2-64
implementing, 2-73
input tape selection, 2-53
invoking with OPEN, 3-5
length checking during, 2-41
output tape selection, 2-17
overriding, 2-84
positioning multifile data sets, 2-14
purpose of, 2-12
searching in desired order, 2-84
tape files, 2-12
verifying tape ownership, 2-58
with
CA Dynam/D, 4-24
utility programs, 3-1
B
Backing up
Catalog, 2-54
DA files, 6-47
BACKUP command
AUDTUTIL, 12-4, 12-6
DYNCAT, 8-41, 8-43
BACKUP command (VCKDBKRS), 6-48
Basic mode, 12-2
BLDINDEX recovery, 4-36
BLKSIZE= parameter
DYNCOPY program, 13-5
Block size
calculating, 6-22
FI operands, 6-22
TDYNCOPY, 3-8
Blocking factor, 3-9
BSF response to MOUNT message, 2-16
Index–2
User Guide