CA Dynam for VSE User Guide

Using CA Dynam/T
When enabling/disabling a particular path, a message is displayed for this
CPU.
AR 015 CADC544I RECEIVE PATH CA12DYN (CA1MVS) ENABLED
AR 015 CADC544I RECEIVE PATH CA12DYN (CA1MVS) DISABLED
Request or discontinue logging of events for the CA12DYN pathid. The type of
event is unspecified here, defaulting to ALL three event types (PLIST, VERIFY,
and RECEIVE).
DT PATH LOG ON CA12DYN
DT PATH LOG OFF CA12DYN
When requesting/discontinuing logging of a particular pathid, a message
appears for the RECEIVE pathid specified. In this example, it is the CA12DYN
path.
AR 015 CADC545I LOG STARTED FOR RECEIVE PATH CA12DYN (CA1MVS)
AR 015 CADC545I LOG ENDED FOR RECEIVE PATH CA12DYN (CA1MVS)
Request or discontinue tracing of events for the CA12DYN pathid. The type of
event is unspecified here, defaulting to ALL three event types (PLIST, VERIFY,
and RECEIVE).
DT PATH TRACE ON CA12DYN
DT PATH TRACE OFF CA12DYN
When requesting/discontinuing tracing of a particular pathid, a message
appears for the RECEIVE pathid specified.
AR 015 CADC545I TRACE STARTED FOR RECEIVE PATH CA12DYN (CA1MVS)
AR 015 CADC545I TRACE ENDED FOR RECEIVE PATH pathid (CA1MVS)
Automatic Retry Facility
CA Dynam/T provides an automatic retry of the AVR scan for input or output
tapes if you so specify in the DYNAM/T option record. This facility notifies the
operator of a required mount for a specific input tape or a scratch tape using
the normal mount message, then goes to sleep for a user-specified interval
without requiring an operator response, allowing the operator to locate the
volume and mount it on an available drive.
Chapter 2: Maintaining Tape Files 2–29