CA Dynam for VSE User Guide

Parameter Statements
TAPEOUT
DISKOUT
Output tape (always standard-labeled)
Output disk file
To specify a DTFname of your choosing for the input tape or disk file, specify
FILEIN= or INNAME= on a DYNCOPY control statement. To specify your own
DTFname for the output tape or disk file, specify FILEOUT= or OUTNAME= on
a DYNCOPY control statement.
Parameter Statements
If DYNCOPY is executed from the console, it will read its parameters from the
console. After the last parameter has been entered, pressing (END/ENTER)
with no data will cause DYNCOPY to begin executing the required functions. If
DYNCOPY is executed from SYSRDR, it will read its parameter statements from
SYSIPT, and at least one statement must be input to specify the type of copy
or dump wanted.
Parameters may be specified in any order, on any number of statements, but
the first parameter on each statement must begin in column 1, and no
parameter may be continued onto another statement. Parameters on the
same statement must be separated from each other by a single comma or
blank, and may extend into column 80. Comments may be placed on the
statement if at least two blank columns are left between the end of the last
parameter and the beginning of the comment.
Parameters
DUMP
COPY
SEL=ALL
Produces a dump of the file with no deblocking of records when the records
are printed. The COPY, MAX=, SKIP=, and CHARONLY parameters may be
used with DUMP, but the SEL= parameter may not be used. All other
parameters used with DUMP will be ignored.
Causes the input file to be copied to tape or disk. If a full copy of the file is
wanted, with no reblocking, no other parameters are needed. If a selective
copy is to be made, the SEL=, LRECL=, BLKSIZE=, and RECFM= parameters
are required. If COPY is used without SEL=, RECFM=, and LRECL= all being
specified, DYNCOPY uses a DTF with undefined records for the output file. The
copy will be correct, but the record size and block size saved on the CA Dynam
Catalog will be missing or incorrect. COPY is the default parameter if no
command is specified.
All records will be selected for copying and/or printing.
13–2 User Guide