CA Dynam for VSE User Guide

Using CA Dynam/T
Shown next are examples of DTPATH commands that correspond to paths
defined in this DTPATH option record example.
DT PATH Examples:
Display the status of all paths for this CPUID.
DT PATH QUERY ALL
The following messages are issued in response to querying ALL paths. They
show the status for all paths controlled by this CPU. (CA1MVS) is the NODEID
of the CPUID sending transactions on this path and the return code is the
highest recorded for this path. The status will display whether the path is
currently enabled, and whether any traces or logs are pending for this path.
AR 015 CADC540I RECEIVE PATH=CA12DYN (CA1MVS) ADDR=0048AB98
AR 015 CADC540I LAST EXEC=12:12:05 LAST REC=________
AR 015 CADC540I NUM REC=0 ERRS=0 : RC=00000020 : STATUS=ENABLED
AR 015 CADC541I SEND PATH=DYN2CA1 : STATUS=ENABLED
Display the status of the CA12DYN path for this CPUID.
DT PATH QUERY CA12DYN
If a particular path, in this case CA12DYN, is queried, the following messages
result:
AR 015 CADC540I RECEIVE PATH=CA12DYN (CA1MVS) ADDR=0048AB98
AR 015 CADC540I LAST EXEC=12:12:25 LAST REC=________
AR 015 CADC540I NUM REC=0 ERRS=0 : RC=00000020 : STATUS=ENABLED
Enable or disable all receive paths for this CPUID.
DT PATH ENABLE ALL
DT PATH DISABLE ALL
When enabling/disabling ALL paths, a message is displayed for each affected
path of this CPUID. In this case, only the CA12DYN pathid corresponds.
AR 015 CADC544I RECEIVE PATH CA12DYN (CA1MVS) ENABLED
AR 015 CADC544I RECEIVE PATH CA12DYN (CA1MVS) DISABLED
Enable or disable a particular receive path, in this case CA12DYN, for this
CPUID.
DT PATH ENABLE CA12DYN
DT PATH DISABLE CA12DYN
2–28 User Guide