CA Dynam for VSE User Guide

Reporting Commands
The second report is the same as the first, except that there is a blank line
before the page title starts. The blank line is caused by the ANSI control
character (0) in the first title ('0REPORT2').
AUDIT TRAIL UTILITY PROGRAM
REPORT 2
REPORT on DISK DATA SET
AND VOLUME USAGE
VOLUME
--- D A T A S E T N A M E --- SERIAL
VBWORK
VSFILE
SYSWK1
SYSWK2
The third report prints the date the report was generated and a page title.
Both lines are left-justified on the page. The field title for volume serial
number is printed on three lines. Note that the third line (NUMBERS) is shifted
one character to the left.
AUDIT TRAIL UTILITY PROGRAM
88/12/02
REPORT on DISK DATA SET AND VOLUME USAGE
DATA SET NAME
VOLUME
SERIAL
NUMBERS
VBWORK
VSFILE
SYSWK1
SYSWK2 Notes:
• You may include the strings YY/MM/DD or HH.MM.SS. The Audit Trail
facility will replace these with the current date and time, respectively.
Make sure that you code these strings as shown.
• If the TITLE text (within apostrophes) exceeds position 72, you can
continue it starting in position 1 on the next statement.
• The maximum length of a page title is 120 characters (excluding the ANSI
control character). If you specify a title larger than 120 characters, only
the leftmost 120 characters are printed.
• The maximum length of a field title is 120 characters. The titles are moved
into the output line in the order in which you specified them. If any overlap
occurs, only the last specified title is printed correctly.
• There is a maximum of seven titles (page and field). All other titles are
ignored.
• Insert two consecutive apostrophes to specify an apostrophe as part of the
title text.
12–28 User Guide