CA Dynam for VSE User Guide

Reporting Commands
TITLE Command
The TITLE command overrides CA Dynam defaults for the titles used on the
report (page titles and field titles).
Format for page title:
TITLE ('page-title' [LEFT|RIGHT])
or
TITLE 'page-title1' 'page-title2' ...
Format for field title:
TITLE (field-name [line-number [position]]) 'field-title'
Page Title
The page title format prints a user-defined title at the top of each report page.
LEFT and RIGHT are optional parameters indicating left or right justification of
the page title. If you specify neither, you may omit the parentheses and the
title is centered across the page. If all titles are to be centered, you can use
the same format to string the page titles on one statement.
You can issue several TITLE commands. They are printed on separate lines in
the order in which they are issued. The first character of each page title should
be an ANSI control character (blank, '0', '+', or '-'). If the first character is not
a valid ANSI control character, CA Dynam forces single-line spacing.
Field Title
This specifies a user-defined title as the heading for the identified field.
Line-number is the title line on which this field title is to be printed: 1 for the
first field title line, 2 for the second field title line, and so on. Default: 1.
Position is the print position at which the field title is to begin, relative to the
beginning of the field on the report line. Default: 0.
A negative position (-nn) indicates that the title is to begin 'nn' spaces before
the start of the field.
If you omit both the line number and position, you can also omit the
parentheses that would have surrounded them.
You can specify as many user-defined field titles as needed. They replace the
default field titles. For more information about the default titles, see Report
Fields.
12–26 User Guide