CA Dynam for VSE User Guide

Using CA Dynam/T
All parameters for the DT PATH command are positional and must be specified
in the format shown above.
DISABLE
DISPATCH
ENABLE
LOG
Disables a specific receive path or all receive paths for this CPUID.
Forces a specific receive path or all receive paths for this CPUID to be read,
even though it has been disabled.
Enables a specific receive path or all receive paths for this CPUID. A receive
path is one defined for another CPUID with a TO value specifying this CPUID.
Enables logging of various events for a specific receive path or all receive
paths. The events to be logged can be indicated as:
PLIST
VERIFY
RECEIVE
ALL
Displays a list of adapter calls and requesters, to be used
in the event of an unexpected return code.
Logs all VERIFY transactions sent or received by this
CPUID.
Logs all VOLUME transactions received by this CPUID.
Default. Enables logging for the PLIST, VERIFY, and
RECEIVE.
You can specify one type of event or a combination of event types listed above
for LOG.
QUERY
TRACE
Displays the status of a specific path or all paths for this CPUID.
Enables the trace facility to trace various events for a specific receive path or
all receive paths. The events to be traced can be indicated as:
ADAPT
PATH
CAT
ALL
All adapter type calls, except PATH and CATALOG type
calls.
PATH function adapter calls only.
CATALOG function adapter calls only.
For all adapter type calls, is the default.
Use this parameter only at the request of CA Technical Support personnel. You
can specify one type of event or a combination of event types listed above for
TRACE.
2–26 User Guide