CA Dynam for VSE User Guide

Maintenance Commands
Note:
• The Audit Trail records to be processed are retrieved first from the Audit
Trail history tape(s), if any exist, then from the Audit Trail disk file.
• If you omit the DATE= operand, the CATALOG RECOVERY command
processes only those Audit Trail records logged after the last BACKUP of
the existing Catalog file. All other Audit Trail records are ignored.
• The Catalog recovery operation does not clear the Audit disk file. Only the
BACKUP function clears the Audit disk.
• During the recovery operation, CA Dynam always processes the Audit trail
history tapes used as input during the recovery as uncontrolled data sets -
- even if the tape file's data set name is in the CA Dynam Catalog. During
the recovery operation, the data contained in the Catalog may be
unreliable.
• Use the LIST option during Catalog recovery to log each operation.
DATASET Command
The DATASET command performs various general purpose functions on the
Audit Trail data set. The operands indicate the functions.
The format of the command is shown below.
DATASET {INITIALIZE [LOGMODE=BASIC|EXTENDED] [SHARE=VSELOCK|YES|NO] }
{STATUS }
{UNLOCK }
The following parameters are mutually exclusive.
INITIALIZE
STATUS
UNLOCK
Initializes the Audit Trail data set so that it can be used by AUDTUTIL.
Reports on the status of the data set.
Unlocks the data set when a lock-out condition occurs. This may happen when
SHARE=YES is in effect, and a job is canceled while the Audit Trail data set is
being updated.
Optional parameters
The following parameters are optional but not mutually exclusive. Each
parameter can be used only in combination with the INITIALIZE parameter.
LOGMODE=
This includes the following:
BASIC
Only logs information necessary for Catalog recovery to
the Audit Trail file.
12–10 User Guide