CA Dynam for VSE User Guide

Maintenance Commands
LIST
Optional parameter. Prints a listing of Catalog recovery operations as each
Catalog entry is recovered. A printed message indicates the Catalog function
performed, the data set name, volume serial number, version, volume
sequence when applicable.
DATE=mm/dd/yy or dd/mm/yy
Optional parameter. Indicates the starting date from which Audit Trail records
will be processed. All Audit records with an older date are ignored. Use this
operand with caution: the date you supply overrides the last 'backup' date,
which is contained in the Catalog time-stamp record (CCR).
Default: date and time of the last backup as indicated in the CCR for the
existing Catalog.
TIME=hh.mm.ss
Optional parameter. Indicates the time of day (using a 24-hour clock) for the
first audit entry to be used in the Catalog recovery. You can include this
operand only if you also specify the DATE= operand. If you specify DATE=
without the TIME= operand, the default is 00.00.00.
Examples
CATALOG RECOVERY command examples are as follows:
(1) CATALOG RECOVERY TAPE=SYS005
(2) CATALOG RECOVERY MULTITAPE=3 DATE=01/01/00
Example 1 shows the following:
• The Audit Trail tape is assigned to logical unit SYS005.
• After the Audit backup tape file is processed, the Audit disk file is to be
processed.
Example 2 shows the following:
• The Audit Trail tape is assigned to logical unit SYS005 by default.
• Three Audit Trail history tapes are to be processed.
• Only audit records with a date after January 1, 2000 are to be processed.
Example Job Stream
// JOB RECOVERY
// ASSGN SYS005,181
// TLBL DYNHIST
// EXEC AUDTUTIL,SIZE=128K
CATALOG RECOVERY NODISK LIST TAPE=SYS005
/*
/&
12–8 User Guide