CA Dynam for VSE User Guide

AUDTUTIL Control Statement Syntax
AUDTUTIL Control Statement Syntax
The following rules apply to AUDTUTIL statement syntax:
• Commands can begin in any position of the statement.
• All operands are separated by one or more blanks.
• Commands can continue onto a maximum of six continuation statements.
The first nonblank character on the next statement begins the next
operand.
• Only positions 1-72 are examined by the AUDTUTIL program.
• You can enter any number of Audit Trail commands, in any sequence, in a
single execution of the AUDTUTIL program.
• All output is written to SYSLST except for some initial messages which are
displayed at the operator's console.
• Continuation requires a nonblank character in position 72 of the statement
to be continued.
Commands may be issued from the console to dynamically generate audit
reports.
Maintenance Commands
AUDTUTIL enables you to perform various maintenance functions on the
accumulated Audit Trail data. The chart below lists each maintenance
command and briefly describes its functions.
This Command
BACKUP
CATALOG RECOVERY
DATASET
Performs These Functions
Backs up the Audit Trail file, merging the data to a
history tape, then clearing the disk data set of all
active entries.
Updates an existing Catalog file with information from
the Audit Trail data set.
Initializes, reports on, unlocks, locks, and sets logging
support for the Audit Trail data set.
Chapter 12: Maintaining and Reporting on the Audit Trail 12–5