CA Dynam for VSE User Guide

Using CA Dynam/T
DT RUN cuu|ALL
DT STATUS
DT STATUS cuu
DT STATUS pp
DT STATUS FREE
Unload the named tape drives.
Show status of all tape drives.
Show status of a particular tape drive.
Show status of all tape drives available to the partition specified (pp). Drives
are shown in the order in which they will be AVRed in this partition.
Show status of all tape drives that are in a ready status with no tape mounted,
are unassigned, and are attached to the machine issuing the command.
DT UNLOCK cuu|TAPES nnn|ALL
Issue unlock for specified tape drives.
** This is only seen when using the IUCV interface and an unusual situation
occurs.
Note: The format of these commands has changed from previous releases of
CA Dynam. However, for reasons of compatibility, the previous command
format of 'CA-D/T xxx' is still supported.
The DT PATH Command
The DTPATH command can be used to query and manipulate the
communication paths defined by the DTPATH option record.
For more information about the DTPATH option record, see the chapters
"Installation Options" and "Using CA Dynam with Special Environments" in the
Programming Guide.
DT Path [ Query {ALL|pathid } ]
[ ]
[ ENable {ALL|pathid } ]
[ ]
[ DISAble {ALL|pathid } ]
[ ]
[ TRace {ON|OFF } {ALL|pathid } [ ADAPT]]
[ [ PATH ] ]
[ [ CAT ] ]
[ [ ALL ] ]
[ ]
[ Log {ON|OFF } {ALL|pathid } [ PLIST]]
[ [ VERIFY ] ]
[ [ RECEIVE ] ]
[ [ ALL ] ]
[ ]
[ DISPatch {ALL|pathid } ]
Chapter 2: Maintaining Tape Files 2–25