CA Dynam for VSE User Guide

AUDIT Data Set Directory Panel—CA Dynam/T (AUDT-1900)
Event Code
Date
Time
PID
Jobname
Phasename
Dataset Name
The event code of the event that occurred. Also a selection field. For more
information about a list of valid event codes, see the Message Guide.
The date the event occurred. Also a selection field.
The Time the event occurred. Also a selection field.
The Partition (Syslog ID) that the event occurred in. Also a selection field.
The Jobname of the job that the event occurred in. Also a selection field.
The name of the Phase that was executing when the event occurred. Also a
selection field.
The name of the data set that was being processed when the event occurred.
Also a selection field. This field may appear as blanks if the label has not been
processed at the time the audit entry has been logged or in the case of some
job control opens, and so on.
Local Commands
BACkward nnn Scroll backward nnn panels. The default is 1.
BOTtom
Scroll to the bottom of the panel display.
DOwn nnn Scroll down nnn lines. The default is 1.
FORward nnn Scroll forward nnn panels. The default is 1.
TOP
Scroll to the top of the panel display.
UP nnn Scroll up nnn lines. The default is 1.
Chapter 11: CAIAUDIT in Prompt Mode 11–7