CA Dynam for VSE User Guide

Using CA Dynam/T
REL (response to MOUNT message)
BG // JOB LOADMSTR
DATE 01/22/09,CLOCK 20/52/31
BG // TLBL SYS005,'AR MSTR BKUP,U'
BG // ASSGN SYS005,29A
BG // EXEC ARLOAD
BG CADT004I MOUNT VOLUME 000379 DSN=AR MSTR BKUP SYS005
BG CADT002D *INTERV REQ* SYS005=29A
BG STATUS
BG CADT015I 298 - F2 - SYS021
BG CADT015I 299 - UA - RDY LP/W 000379 AR MSTR BKUP
BG CADT015I 29A - BG - SYS005
BG CADT0041 MOUNT VOLUME 000379 DSN=AR MSTR BKUP SYS005
BG CADT002D *INTERV REQ* SYS005=29A
BG REL
BG CADT032I ASSIGNED SYS006 SYS006=299 000379 AR MSTR BKUP
BG EOJ LOADMSTR
DATE 01/22/09,CLOCK 21/03/32,DURATION 00/11/01
The tape volume called for was mounted on a drive other than the one to
which the JCL assigned it. The operator responds REL to release the
assignment and force AVR rather than move the tape from 299, where it was
mounted and ready, to its assignment at 29A. CA Dynam/T locates the tape
and the file is processed.
Had the JCL been originally submitted without the // ASSGN SYS005,29A
statement to take full advantage of AVR, the volume would have been located
on the first AVR scan, and none of the console dialog would have been
required.
DISK (response to MOUNT message)
BG // JOB BUILDMST
DATE 01/22/09,CLOCK 20/52/31
BG // TLBL ARMTAP,'AR MSTR OUT,U'
BG // EXEC ARCREATE
BG CADT008D MOUNT SCRATCH ARMTAP SYS006 DSN=AR MASTER OUT BUILDMST
BG STATUS
BG CADT015I 298 - F2 - SYS021
BG CADT015I 299 - F2 - SYS022
BG CADT015I 29A - UA - *LOCKED*
BG CADT008D MOUNT SCRATCH ARMTAP SYS006 DSN=AR MASTER OUT BUILDMST
BG DISK
BG CADD002I ALLOCATED FILE=ARMTAP SYS038=15C SYSWK1 IX=00/204/40 (G#06)
BG EOJ BUILDMST
DATE 01/22/09,CLOCK 21/03/32,DURATION 00/11/01
Chapter 2: Maintaining Tape Files 2–23