CA Dynam for VSE User Guide

Test Program Generator - DYNATEST
REQ=
Optional parameter. Determines the basic type of retrieval to be performed by
the generated program. Choose only one of these values:
SD, GD, DD, SV, GV, DV, CC, or VC
• If CC or VC is specified, a maximum of one call is made to DYNACC, after
which the program will terminate.
• For other types, additional calls will be constructed and executed to ensure
that all volumes (for data set type calls) or files (for volume type calls) for
each data set or volume are retrieved.
• For direct calls (Dx), the generated program terminates once the specified
data set or volume has been completely processed.
• For sequential or generic calls (Sx or Gx), the program terminates when
DYNACC indicates an end condition exists.
In any case, the program terminates normally when the NCALLS counter
decrements to zero.
SYSTEM=
Optional parameter. Determines which operating system environment to
generate support for.
DOS or CMS (defaults to DOS)
V= Optional parameter. Determines whether the generated program is to use
Version 2 or Version 1 format DYNINFO to call DYNACC. Choose either 2 or 1
(defaults to 2)
VER=nnn
Optional parameter. Identifies the version number of the data set to retrieve
for a direct data set call (DD).
a 1- to 3-digit number in the range 1-255
If omitted, version one of the data set is assumed.
VOL=xxxxxx
Optional parameter. Specifies the volume serial number to retrieve for a direct
(Dx) call.
1-6 alphanumeric characters
VSQ=nnnn
Optional parameter. For a multivolume file version, for a direct data set (DD)
call, specifies the volume sequence number of the first volume to retrieve. As
many subsequent volumes are retrieved as exist and can fit in DYNINFO (see
also the NVBRS parameter).
a 1- to 4-digit number
10–22 User Guide