CA Dynam for VSE User Guide

Test Program Generator - DYNATEST
FSQ=nnnn
Optional parameter. For a multifile tape volume, for a direct volume (DV) call,
specifies which data set version is to be retrieved.
a 1- to 4-digit number
GDG=xxxxxxxx
Optional parameter. Identifies the generation to retrieve, based on the
operating system generation data set group you specify here.
1-8 alphanumeric characters
GEN=nnn
Optional parameter. Specifies the CA Dynam/D data set version to retrieve for
a direct data set call (DD).
a 1- to 3-digit number in the range 1-999
If omitted, the most current is assumed.
INFO=
Optional parameter. Determines whether descriptive material is generated.
YES or NO (defaults to YES)
NCALLS=nnnnnn
Optional parameter. Specifies the maximum number of calls to make to
DYNACC.
a 1- to 6-digit number in the range 1-999999 (defaults to 999999)
NVBRS=nnnn
Optional parameter. Determines the maximum number of tape volumes for a
single version which may be accommodated in DYNINFO.
a 1- to 4-digit number in the range 1-9999 (defaults to 20)
PCOMM=
Optional parameter. Determines whether the generated program is to build
the request to DYNACC from an argument passed in a DYNPCOMM parameter
list from DYNPRINT, or from the selection arguments passed to this macro.
This is intended to assist in debugging user programs written to execute in the
DYNPRINT execution environment.
NO or YES (defaults to NO)
PSW=xxxxxxxx
Optional parameter. Specifies the password to be supplied to DYNACC.
DYNACC only returns the data set name for password-protected data sets
unless you supply the appropriate password. Supply either the catalog or the
data set password.
1 to 8 alphanumeric characters
Chapter 10: Accessing the Catalog 10–21