CA Dynam for VSE User Guide

Using CA Dynam/T
The operator responds RERUN to the CADT004D MOUNT message to force
CA Dynam/T to flag Version 1 of AP RP MASTER for scratch. Note that volume
100665 (which was Version 2) becomes Version 1 and is located immediately
by AVR. The CADT032I message indicates that the desired volume has been
located and the assignment made. Tape 28768 will be scratched the next time
the DYNCAT SCRATCH command is run.
ACCEPT (response to MOUNT message)
BG // JOB ARRPLOAD
DATE 01/22/09,CLOCK 20/25/24
BG // TLBL TAPEIN,'AR RP MSTR,W'
BG // EXEC MSTRIN
BG CADT004D MOUNT VOLUME 028768 AR RP MSTR SYS010
BG 29A
BG CADT005D WRONG TAPE:VOL=100665 HDR1='AR RP MSTR' SYS010=29A
BG ACCEPT
BG CADT032I ASSIGNED TAPEIN SYS010=29A 100665 AR RP MSTR
BG EOJ ARRPLOAD
DATE 01/22/09,CLOCK 20/25/46,DURATION 00/00/22
The operator has directed CA Dynam/T to a tape other than the one called for,
and the CADT005D message is issued showing the volume serial number and
file ID of the tape actually found. An ACCEPT response allows the operator to
override CA Dynam/T and input volume 100665 instead of volume 028768.
ALTER (response to MOUNT message)
BG // JOB ARRPLOAD
DATE 01/22/09,CLOCK 20/26/04
BG // TLBL TAPEIN,'AR RP MSTR,W'
BG // TLBL TAPEIN,'AR RP MSTR,W',,,,,2
BG // EXEC MSTRIN
BG CADT004D MOUNT VOLUME 028768 AR RP MSTR SYS010
BG ALTER
BG CADT032I ASSIGNED TAPEIN SYS010=29A 100665 AR RP MSTR
BG EOJ ARRPLOAD
DATE 01/22/09,CLOCK 20/26/23,DURATION 00/00/19
The operator responds ALTER to the CADT004D MOUNT message to force
CA Dynam/T to drop the first TLBL and instead use the second. The second
TLBL calls for Version 2 of the data set. If the ALTER response is to be used,
the second TLBL must be available; otherwise, the job will cancel with NO
LABEL INFORMATION.
Chapter 2: Maintaining Tape Files 2–21