CA Dynam for VSE User Guide

Using CA Dynam/T
REWIND (response to MOUNT message)
BG // JOB ARUPD
DATE 01/23/09,CLOCK 20/00/43
BG // TLBL TAPEIN,'AR TRANS,U'
BG // TLBL TAPEOUT,'AR MASTER,W'
BG // EXEC MSTRIO
BG CADT004D MOUNT VOLUME 100372 AR TRANS SYS010
BG STATUS
BG CADT015I 298 - UA - RDY LP/W *NOT-CAP*
BG CADT015I 299 - UA - RDY NLPW
BG CADT015I 29A - UA - RDY LP/W 100733 BGWORK
BG CADT004D MOUNT VOLUME 100372 AR TRANS SYS010
BG 299
BG CADT002D *NOT LD PNT* SYS010=299
BG REWIND
BG CADT004D MOUNT VOLUME 100372 AR TRANS SYS010
BG
BG CADT032I ASSIGNED TAPEIN SYS010=299 100732 AR TRANS
BG CADT007I ****** LABEL TAPEOUT SYS011=29A 100733 1 *AR MASTER*
BG CADT031I *CLOSED* TAPEOUT SYS011=29A 100733 AR MASTER BLK=54
BG EOJ ARUPD
DATE 01/23/09,CLOCK 20/01/34,DURATION 00/00/51
CA Dynam/T is unable to locate the desired volume during AVR; the
CADT004D MOUNT message is issued. A STATUS reveals that drive 299 is
unassigned, but not at load point. The operator directs CA Dynam/T to drive
299 and receives CADT002D NOT LD PNT. The operator replies REWIND to
cause the tape to be rewound. The next time AVR is performed, the desired
volume is located, the CADT032I message is issued and processing continues.
Note that STATUS shows that the density of the tape on drive 298 makes it
incapable of being read by the tape drive.
RERUN (response to MOUNT message, to rerun AVR of input tape)
BG // JOB ARRPLOAD
DATE 01/22/09,CLOCK 20/26/49
BG // TLBL TAPEIN,'AR RP MAST,W'
BG // EXEC MSTRIN
BG CADT004D MOUNT VOLUME 028768 AR RP MAST SYS010
BG RERUN
BG CADT032I ASSIGNED TAPEIN SYS010=29A 100665 AR RP MSTR
BG EOJ ARRPLOAD
DATE 01/22/09,CLOCK 20/27/07,DURATION 00/00/18
2–20 User Guide