CA Dynam for VSE User Guide

Using CA Dynam/T
BG
BG CADT007I **** LABEL UOUT SYS005=29A 1004561 *AR MASTER*
BG CADT509I BLOCK COUNT=0000002 INPUT
BG CADT510I BLOCK COUNT=0000002 OUTPUT
BG CADT031I *CLOSED* UOUT SYS005=29A 100456 AR MASTER BLK=53
BG EOJ COPY
DATE 01/23/09,CLOCK 20/31/53,DURATION 00/01/19
1. This copies an unlabeled tape file, UIN, to a labeled tape file, UOUT,data
set AR MASTER. Rewinds output tape at CLOSE.
2. No assignment is in effect for the input tape; the CADT001D message is
issued.
3. The operator directs CA Dynam/T to drive 299 for input.
4. No SCRATCH tape is available. After getting a status report of the tape
drives, the operator initializes the tape on 29A as volume 100456, and
processing continues. Note that the STATUS shows drive 299 already
assigned to SYS004 in BG.
JCL assignments for controlled tapes
F2 // JOB ARDESCUP
DATE 01/22/09,CLOCK 20/46/38
F2 // ASSGN SYS010,299
F2 // TLBL TAPEIN,'AR DESC 1',,,,,,2
F2 // ASSGN SYS011,29A
F2 // TLBL TAPEOUT,'AR DESC 1',,,,,,2
F2 // EXEC MSTRIO
F2 CADT032I ASSIGNED TAPEIN SYS010=299 100723 AR DESC 1
F2 CADT008I MOUNT SCRATCH TAPEOUT on 29A DSN=AR DESC 1 MODE=1600
F2 CADT017D *INTERV-REQ* 29A
F2 STATUS
F2 CADT015I 298 - UA- NOT AVBL
F2 CADT015I 299 - F2 - SYS010
F2 CADT015I 29A - F2 - SYS011
F2 CADT008I MOUNT SCRATCH TAPEOUT ON 29A DSN=AR DESC 1 MODE=1600
F2 CADT017D *INTERV REQ* 29A
F2
F2 CADT007I **** LABEL TAPEOUT SYS011=29A 100744 1 *AR DESC 1*
F2 CADT031I *CLOSED* TAPEOUT SYS011=29A 100744 AR DESC BLK=14
OJ ARDESCUP
F2 DATE 01/22/09, CLOCK 20/49/40,DURATION 00/03/02
JCL assignments for SYS010 and SYS011 are in effect. Note the difference in
the CADT008I message, and the CADT017D *INTERV REQ* message. The
operator is required to use drive 29A for the output file, because JCL
assignments are in effect. Note that STATUS shows 298 is not available for
processing, probably having been placed offline or detached.
Chapter 2: Maintaining Tape Files 2–19