CA Dynam for VSE User Guide

Reporting on the Catalog
Report Samples
For more information about samples of active catalog files, see the chapter
"CA Dynam Report Examples."
Invoking the Report
Use the following DYNPRINT command sequence to invoke ACTVFILE:
ACCESS CATALOG
REPORT ACTVFILE [ options ] or REPORT ACTIVEFILES [ options ]
Options for ACTVFILE or ACTIVEFILES:
[ BANNER ]
[ CATNM ]
[ CBUFN ]
[ DSN ]
[ DVC ]
[ EROPT ]
[ PSW ]
[ MAXLINES ]
[ MAXRETR ]
[ MAXVERS ]
[ SELECT= {option[,option..] } ]
The MAXVERS and SELECT options are described here. For more information
about all other ACTVFILE options and their application, see REPORT and
COMPILE Commands.
MAXVERS Option
SELECT Options
FIDVER
OWNERID
SYSTEMID
USERID
VOLSER
The MAXVERS option specifies the maximum number of versions to be
reported on for each (generation-type) file. If MAXVERS=1 is given, only the
most recent version of each file is reported.
The SELECT options for ACTVFILE are all sort-order options. Any or all of
them may be used, to produce up to five reports from one command. They
are:
Files are sorted on file-id/version. This is the default option if the SELECT
keyword is omitted.
Files are sorted on owner-id/file-id.
Files are sorted on system-id/file-id.
Files are sorted on user-id/file-id.
Files are sorted on volser/file-seq/file-id. For disk files, the second sort
variable is set to 0, so that disk files are sorted on file-id only within each
volume.
Chapter 9: CA Dynam Reporting Utilities 9–17