CA Dynam for VSE User Guide

General Reporting−DYNPRINT
VER=nnn
VOL=xxxxxx
VSQ=nnnn
Optional parameter; valid only for CATALOG reports. Identifies the version
number of the data set to be reported on.
Optional parameter; for CATALOG reports, identifies the volser or generic
volser to be reported on. For VTOC reports, identifies the volser, generic volser
or CA Dynam/D pool to be reported on. For either type, a generic key value
may be specified by following the last significant character in the volser by an
asterisk.
Optional parameter; valid only for CATALOG reporting on multivolume data
sets. Specifies the volume sequence number of the volume to be reported on.
Selection parameters are optional. If you supply any, each one must contain a
keyword followed by an appropriate numeric or alphanumeric value. If you
omit them, defaults are used to determine the data to be retrieved.
Parameters are dependent on the report specified.
Standard DYNPRINT Reports
Report Types
Basically, there are six different standard reports currently supplied with CA
Dynam. They are divided into catalog-based or VTOC-based report classes.
Catalog-based reports are further subdivided into DSN-entry reports and VOLentry
reports.
DSN-entry reports access the Catalog sequentially by data set name, and can,
by extension, report on series of the following:
• Versions for each data set
• Tape volumes or disk extents for each version
VOL-entry reports access the Catalog sequentially by volser (only tape
volumes being supported) and can by extension report on series of files (or
versions of files) resident on each volume. It is the logic of these access paths
which causes some selection keywords to be excluded for each class of report.
To find out which options are supported by given reports, consult the
documentation for that report.
9–6 User Guide