CA Dynam for VSE User Guide

General Reporting−DYNPRINT
DSN=dsn
DVC= {D|T|F }
Optional parameter; valid only for CATALOG reports. Specifies a specific data
set name to be reported on. May be specified as a generic key, with an '*'
immediately after the last significant character in the name.
Optional parameter; valid only for CATALOG reports. Specifies a device class
filter to be placed on the data sets and generations to be reported in certain
reports. Defaults to all data sets.
DISK, or D
TAPE, or T
FI, or F
for DISK data sets
for TAPE data sets
for FI data sets
EROPT=D
FSQ=nnnn
GDG=xxxxxxxx
GEN=nnn
MAXFILES=nnn
MAXLINES=nnnnn
MAXVERS=nnn
MAXVOLS=nnn
MAXRETR=nnnnnnn
PSW=xxxxxxxx
REQ=xx
SELECT=
Optional parameter. Causes the access method to generate snap dumps of
selected data areas for certain types of errors. Operation is access method
dependent. This option is intended for debugging.
Optional parameter; valid only for CATALOG reports on multifile tapes. Selects
the file sequence number of the data set version to be retrieved.
Optional parameter; valid only for CATALOG reports. Specifies the generation
of the data set to be reported on, based upon the OS generation data group
identifier of the generation.
Optional parameter; valid only for CATALOG reports. Specifies the version of
the data set to be reported on, based on the CA Dynam/D generation number.
Optional parameter - report dependent.
Optional parameter - report dependent. Usually the maximum lines to be
printed for each individual selected report.
Optional parameter - report dependent.
Optional parameter - report dependent.
Optional parameter - report dependent. Usually the maximum number of
logical retrieves to be performed by the access method.
Optional parameter; valid only for CATALOG reports, is the Catalog or data set
password which enables reporting of password-protected data sets.
Optional parameter. Specifies the initial request code to be passed to the
access method. Overrides the default request code for the report. Access
method dependent. Usually only used for custom reports.
Optional parameter - report dependent.
SELECT= {option[,option..] }
Chapter 9: CA Dynam Reporting Utilities 9–5