CA Dynam for VSE User Guide

General Reporting−DYNPRINT
The only difference between the effect of a COMPILE statement and a REPORT
statement is that COMPILE calls an inline CA Earl compilation prior to
executing the report program.
The format of the command is shown below.
{REPORT|COMPILE } report-name [ ,BANNER=OFF ]
[ ,CATNM=dtfname ]
[ ,CBUFN=nnnn ]
[ ,DSN=dsn ]
[ ,DVC= {DISK|TAPE|FI } ]
[ ,EROPT=D ]
[ ,FSQ=nnnn ]
[ ,GDG=xxxxxxxx ]
[ ,GEN=nnn ]
[ ,MAXFILES=nnn ]
[ ,MAXLINES=nnnnn ]
[ ,MAXVERS=nnn ]
[ ,MAXVOLS=nnn ]
[ ,MAXRETR=nnnnnnn ]
[ ,PSW=xxxxxxxx ]
[ ,REQ=xx ]
[ ,SELECT= {option[,option..] } ]
[ ,VER=nnn ]
[ ,VOL=xxxxxx ]
[ ,VSQ=nnnn ]
report-name
Required parameter. Specifies the report to be invoked. This name is used by
DYNPRINT to derive the name of the report program to invoke and to establish
the default characteristics of the report.
For standard reports, refer to the report documentation for the name and
applicable options. For custom reports, either compiled inline or saved from a
previous compilation, the name is CUSTOMnn, where n is a number between
zero and 99. The associated program name is CUSnn.
By default, all CATALOG custom reports process all data sets in the Catalog in
DSN sequence and all VTOC custom reports process all extents for all data set
names defined in all available VTOCs on the execution system.
BANNER=OFF
CATNM=dtfname
CBUFN=nnnn
Optional parameter. Suppresses the DYNPRINT banner for this report.
Optional parameter; valid only for CATALOG reports. Specifies the dtfname for
the Catalog. Defaults to CAICATL.
Optional parameter; valid only for CATALOG reports. Specifies the number of
Catalog buffers, in a range 3-9999 (defaults to 12).
9–4 User Guide