CA Dynam for VSE User Guide

Using CA Dynam/T
To
Reissue the OPEN for the newly mounted
tape.
Switch to a disk device.
Issue This Response
NEWTAP
DISK
Answering Mount Messages
Examples of JCL and Console Logs:
Output tape selection through AVR
BG // JOB ARDUMP
DATE 01/07/09,CLOCK 23/07/07
BG // TLBL TAPEOUT,'AR TRANS,W'
BG // EXEC MSTROUT
BG CADT007I **** LABEL TAPEOUT SYS011=299 100732 1 *AR TRANS*
BG CADT031I *CLOSED* TAPEOUT SYS011=299 100732 *AR TRANS* BLK=12
BG EOJ ARDUMP
DATE 01/07/09, CLOCK 23/08/09, DURATION 00/01/02
1. This creates the file TAPEOUT, data set AR TRANS. Rewinds the tape at
CLOSE.
2. AVR locates a scratch tape on drive 299, and the CADT007I message is
issued.
3. The file is closed and the CADT031I message is issued. The Catalog is
updated; tape 100732 is now version 1 of data set AR TRANS.
Mounting a scratch tape
BG // JOB ARUPD
DATE 01/21/09, CLOCK 20/03/14
BG // TLBL TAPEOUT,'AR TRANS,W'
BG // EXEC MSTROUT
BG CADT008D MOUNT SCRATCH TAPEOUT SYS011 DSN=AR TRANS MODE=1600
BG STATUS
BG CADT015I 298-UA-* DOWN *
BG CADT015I 299-UA-RDY LP/W 100732 AR TRANS
BG CADT015I 29A-UA-RDY LP/W 100733 AR MASTER
BG CADT015I 29B-UA-*AVRLOCK*
BG CADT008D MOUNT SCRATCH TAPEOUT SYS011 DSN=AR TRANS MODE=1600
BG 29A
BG CADT010D VOLSER 100733 ALREADY IN FILE AS AR MASTER
BG CADT008D MOUNT SCRATCH TAPEOUT SYS011 DSN=AR TRANS MODE=1600
BG STOP
F2 EOJ PAUSE
DATE 01/21/09,CLOCK 20/05/22,DURATION 00/00/53
F1 1Q34I F2 WAITING FOR WORK
Chapter 2: Maintaining Tape Files 2–17