CA Dynam for VSE User Guide

DYNCAT Commands
x
y
x1,y1
Identifies the range's starting number.
Identifies the range's ending number.
Specifies the range of slot numbers.
Valid entries are:
1 to 5 numerics - for the start and end number of a range.
Up to ten ranges of slot numbers may be defined or deleted, accounting for a
maximum of 65,535 slots. Each slot range defined or deleted requires a
unique VAULT VLTLOC= statement.
You may not define slot numbers for vault A.
If slot ranges are added/deleted/changed, this will signal to TDYNVLT to run a
VERIFY automatically at its next execution. However, the automatic VERIFY
cannot be run if a TDYNVLT conversion function was requested.
Example
An example follows:
// JOB DESCRIBE VAULTS
// EXEC DYNCAT,SIZE=128K
VAULT VLTLOC=A DESC='TAPE LIBRARY'
VAULT VLTLOC=B DESC='TAPE VAULT AT BANK' SLOTS=(1001,1250)
VAULT VLTLOC=B DESC='TAPE VAULT AT BANK' SLOTS=(2001,2250)
VAULT VLTLOC=B DESC='TAPE VAULT AT BANK' SLOTS=(3001,3250)
VAULT VLTLOC=B DELETE=(1001,1250)
VAULT VLTLOC=B DELETE=(2001,2250)
VAULT VLTLOC=B DELETE=(3001,3250)
VAULT VLTLOC=B DESC=' '
/*
/&
1 This establishes a description for the tape library itself. Note that vault A is
always the tape library.
2 This establishes a description for vault B, which is "TAPE VAULT AT BANK".
Vault B has three cabinets, each containing 250 slots.
3 This deletes the slot numbers defined in example 2.
4 This deletes vault B's description of 'TAPE VAULT AT BANK' as defined in
example 2.
8–92 User Guide