CA Dynam for VSE User Guide

DYNCAT Commands
−
−
Tape volumes available for use as SCRATCH tapes
Datasets recorded in the Catalog
• Percentage of:
−
−
−
−
Example
Available space in the Catalog
Reserved index area in the Catalog used
All space in the Catalog used
All space in the Catalog used when Catalog was most full
An example follows:
// JOB DISPLAY CATALOG STATUS
// EXEC DYNCAT,SIZE=128K
STATUS
/*
/&
VAULT Command
Use the VAULT command to establish or delete vault descriptions for any or all
vaults to be used. You may also assign or delete storage slots to be used for a
particular vault location. These descriptions are used for reporting purposes
only.
The format of the command is shown below.
VAULT VLTloc=c [ DESC='description' ]
[ SLOTS=(x1,y1)|DELETE=(x1,y1) ]
VLTloc=
Required parameter. Identifies a vault location. Valid entry is:
a 1-alphabetic-character vault ID (A to Z).
DESC=
Optional parameter. Provides or deletes the description of the vault location
identified in VLTloc. Valid entries are:
'description'
100 characters enclosed in apostrophes which describe
the vault.
' 'one space enclosed in apostrophes to delete the vault description.
SLOTS=(x1,y1), DELETE=(x1,y1)
Optional parameters. Assigns or deletes ranges of slot numbers for the
identified vault.
Chapter 8: Maintaining the Catalog−DYNCAT Program 8–91