CA Dynam for VSE User Guide

DYNCAT Commands
Example
The following example establishes the ownership code TEST CATALOG.
// JOB CATALOG OWNERSHIP
// EXEC DYNCAT,SIZE=128K
OWN id='TEST CATALOG'
/*
/&
RENAME Command
Use the RENAME command to assign a new name to an entire dataset or to
assign a new name and version number to a specific version of a tape dataset.
Individual versions of disk datasets may not be modified with RENAME.
The format of the command is shown below.
RENAME OLDNAME='old data set name' NEWNAME='new data set name'
[ ALL| {OLDVERS=nnn|VOLser=xxxxxx }NEWVERS=nnn ]
[ MF=RESET ]
[ PASSWORD='password' ]
OLDNAME=
Required parameter. Specifies the dataset to be renamed. Valid entry is:
a 1- to 44-character data set name enclosed in apostrophes.
NEWNAME=
Required parameter. Specifies the new data set name. Valid entry is:
a 1- to 44-character data set name enclosed in apostrophes.
Note:
• When renaming all the versions of a dataset (ALL operand), the 'new data
set name' must not already exist in the Catalog.
• When renaming just one version of a dataset (OLDVERS or VOLSER
operand), the new data set name must already exist in the Catalog.
PASSWORD=
Required parameter if old name DSN was defined with a password. Valid
entries are:
1- to 8-alphabetic characters enclosed in apostrophes.
8–78 User Guide