CA Dynam for VSE User Guide

DYNCAT Commands
The format of the command is shown below.
LISTcat {'data set name'}
{TAPE['data set name']]
{DISK['data set name']}
{ALL }
or
LISTcat SKR= {'skname'|ALL }
or
LISTcat {VCR|CCR }
or
LISTcat VOL= {volser|ALL }
'data set name'
Optional parameter. Specifies the dataset to be reported on. Valid entries are:
1- to 44-character data set name enclosed in apostrophes
the first n characters of a group of data set names (for a generic report).
TAPE|DISK|ALL
Optional qualifier. Identifies the generic group of datasets to be reported upon.
TAPE or DISK restricts report to either tape or disk datasets, respectively. If
no data set name is entered, all datasets will be displayed within the indicated
group. The listing is presented in alphabetic sequence.
SKR=
Optional parameter. Specifies the sort key record to be reported upon, or if
used with the qualifier ALL, specifies that a generic group of sort key records is
to be reported upon. The listing will be presented in alphanumeric sequence.
Valid entries are:
a 1- to 8-character sort key name enclosed in apostrophes.
the first n characters of a group of sort key names (for generic report if
qualified by ALL).
ALL to display all sort key records.
VCR|CCR
Optional parameter. Specifies what is to be displayed. Valid entries are:
VCR
CCR
for Vault Control Records and slot ranges.
for the Catalog Control Record.
VOL=
Optional parameter. Specifies the volume serial number record(s) to be
reported upon. Volume serial numbers will be presented in alphanumeric
sequence. Valid entries are:
a 1- to 6-character volume serial number.
ALL
to display information about all volume serial number
records in the Catalog.
8–74 User Guide