CA Dynam for VSE User Guide

DYNCAT Commands
unitnumber
Required parameter. Specifies the logical or physical unit number of the device
where the tape to be initialized resides. Valid entries are:
SYSnnn
cuu
Where nnn is the logical unit number (SYS number)
assigned to the tape drive.
The tape drive address.
CLean=
Optional parameter. Specifies the maximum number of tape errors to be
allowed for this volume before CA Dynam/T flags it to be cleaned. This is a
cumulative total that is retained in the Catalog until the tape is reinitialized. A
valid entry is:
a 1- to 3-digit number.
CUU=
DENsity=
Optional parameter. Allows the initialization of multiple tapes starting with
cuu1 up to cuu16. FIRST and LAST volumes must be specified with CUU=.
Optional parameter. Specifies the recording density for this tape. Valid entries
are:
800 for 800 BPI
1600 for 1600 BPI
6250 for 6250 BPI
CART
for tape cartridge
00 for tape cartridge (buffered write mode)
00E
00M
00ME
00MH
00W
00WE
03WE
for tape cartridge (3490E buffered write mode)
for tape cartridge (3590 buffered write mode)
for tape cartridge (3590E buffered write mode)
for tape cartridge (3590H buffered write mode)
for tape cartridge (3592 buffered write mode)
for tape cartridge (3592E buffered write mode)
for tape cartridge (3592E encrypted buffered write mode)
08 for tape cartridge (data compaction with buffered write)
08E
for tape cartridge (3490 data compaction with buffered
write)
8–70 User Guide