CA Dynam for VSE User Guide

DYNCAT Commands
a 1- to 4-digit number in the range 0-9999.
OIMSG=
OOMSG=
OPEN=
See CIMSG operand description.
See CIMSG operand description.
Optional parameter. Specifies the DTF rewind option set by CA Dynam/T or CA
Dynam/FI for OPEN.
NORWD
RWD
Tape is not rewound
Force rewind
OVRfl=
OVRfl=(volser,unit,q1,q2,SYSnnn)
Optional parameter. Specifies the allocation characteristics of the independent
overflow to be generated for the (ISAM) disk dataset if it is to be allocated by
CA Dynam/D. Valid entries are the same as for the PRIME data allocation
(except for the sequence option).
OWner=
Optional parameter. Specifies the ownership code for this dataset. Valid
entries are:
cc
NO
1 or 2 alphanumeric characters.
No ownerid specified. Leaves blank spaces in this field.
1 to 2 alphanumeric characters.
PASSword=
Optional parameter. Specifies the password to be associated with this dataset.
If specified, this password will be required by DYNCAT in order to perform
maintenance on this dataset.
For disk datasets, this password will also be required by CA Dynam/D before
allowing access to the dataset. Valid entry is:
1 to 8 alphabetic characters within apostrophes.
PED=
Optional parameter that specifies the period-ending-date value (as-of-date
value) for this file. Valid entries are:
date
Acceptable date forms are mm/dd/yy or dd/mm/yy.
You may substitute two asterisks for any or all date fields. When CA Dynam/T
encounters the asterisks, it will replace them with that field from the job date
(temporary COMREG date for VSE users).
For example: **/31/** would be changed to 05/31/00 for each version of the
dataset created in May of 2000.
Chapter 8: Maintaining the Catalog−DYNCAT Program 8–55