CA Dynam for VSE User Guide

DYNCAT Commands
CIMSG=
Optional parameter. It defines user-specified messages for the dataset. These
messages will be issued Open Input (OIMSG=), Open Output (OOMSG=),
Close Input (CIMSG=), and/or Close Output (COMSG=) for the dataset, as
specified, and will be directed to the operator console and/or SYSLST as
indicated by the routing code. Routing codes are as follows:
C - Console (default)
P - Printer
B - Both
Valid input is 1 to 70 alphanumeric characters of message text, followed by a
comma, followed by single-character routing code, following optionally by a , A
if message should ring the console. All are enclosed by apostrophes.
Example
OIMSG='MY MESSAGE,C'
OOMSG='MY MESSAGE FOR OUTPUT, C,A'
CLOSE=
Optional parameter that specifies the DTF rewind option set by CA Dynam/T or
CA Dynam/FI for CLOSE.
NORWD
RWD
UNL
tape is not rewound
force rewind
force rewind and unload
COMment=
Optional parameter. Specifies the comment field to be associated with this
dataset. Valid entries are 1 to 100 alphanumeric characters enclosed in
apostrophes.
Note that, even though up to 100 bytes of comment may be specified, the
comment shown on some reports may be truncated due to space limitations.
COMSG=
DEFvlt=
See CIMSG operand description.
Optional parameter. Defines the default vault location for all versions of the
dataset not specified by VLTLOC parameter. Normally, the default vault
location is A. Valid entry is:
One alphabetic character in the range A-Z.
If omitted, the main tape vault (A) is assumed.
8–48 User Guide