CA Dynam for VSE User Guide

DYNCAT Commands
[ [,ROTATE ] ]
[ USerid=cc ]
[ VIRTape={NO|VTAPE|FTAPE} ]
[ VLTloc=(A,B,C,...,Z) ]
[ VOLID=cc ]
[ WORK= {YES|NO } ]
[ MODEL='data set name' ]
'data set name'
ALLoc=
Required positional parameter. Specifies the dataset to be defined. Valid entry
is 1 to 44 characters enclosed in apostrophes for DISK, TAPE or FI.
ALLoc=(volser,unit,q1,q2,q3,SYSnnn)
Optional parameter. Defines the allocation characteristics of a disk dataset if it
is to be allocated by CA Dynam/D. Valid entries are specified within
parentheses and are separated by commas. (Do not omit commas unless they
immediately precede closing parenthesis.)
All of the characteristics of the allocation information are defined when an
ALLOC is processed. Complete ALLOC information must be entered on the
command. The ALLOC parameter may not be used for ISAM files. For ISAM,
the PRIME, INDEX, MINDEX and OVRFL parameters must be used.
volser
unit
Volume serial number upon which the extent is to reside.
May be either a real, virtual (pool) or generic volser. The
default is '******', which defines allocation on any
mounted pack.
Unit of allocation for the extent. Valid entries are:
TRK
CYL
BLK
RCD
for tracks
for cylinders
for FBA blocks
for number of records
The default is TRK. Nonsequential files (DA, ISAM) are
always treated as TRK.
q1
q2
q3
Number of units to allocate for primary allocation. Valid
entries are in the range 0-999999. This is a required
operand.
Number of units to allocate for each secondary allocation.
Valid entries are in the range 0-999999. The default is 0.
Number of secondary allocations to perform. Valid entries
are in the range 0-255. The default is 0.
8–46 User Guide