CA Dynam for VSE User Guide

DYNCAT Commands
CANCEL|NOCANCEL
ERR|NOERR
LOG|NOLOG
Optional parameter. Indicates whether the job will be canceled if an error is
encountered in the input stream.
Optional parameter. Requests or suppresses the display of message
CADC801E on the console if an error is encountered in the input stream.
CADC801E will be written only once per execution.
Optional parameter. Specifies whether each control statement will be logged
on the console as it is processed.
The following example sets the LOG and CANCEL options for the first part of
the run, then changes to NOCANCEL for the remainder of the run. Note that
the ERR option was not affected by either ACTION statement. Also the LOG
option set by the first ACTION statement was not affected by the second
ACTION statement.
// JOB CHANGE OPTIONS
// EXEC DYNCAT,SIZE=128K
ACTION LOG CANCEL
.
.
.
ACTION NOCANCEL
.
.
.
/*
/&
ADD Command
Use the ADD command to place tape files under control of CA Dynam/T after
they have been created. You can use the ADD command to add versions to
datasets or volumes to versions that are already in the Catalog file or to define
externally owned tape volumes. You can also use this command to add VTAPE
versions to the Catalog file.
The format of the command is shown below.
To add versions or volumes:
ADD 'data set name' VOLser=(xxxxxx,...)
[ APPEND= {YES|NO } ]
[ CREate=date ]
[ DISK ]
[ EXPdate= {date|RETAIN|PERM } ]
[ FILE=nn ]
[ GDSid=nn ]
[ JOBname='jobname' ]
8–12 User Guide