CA Dynam for VSE User Guide

Preparing for CA Dynam/T
Examples:
Initialization of scratch tapes with DYNCAT
DYNCAT is executed from the console and the tapes on drives 299 and 29A are
initialized and rewound. The absence of a volume serial number in the
CADT009D message indicates that the tapes were originally unlabeled. The
operator enters the new volume serial numbers 100732 and 100733 and
enters EOB/END in response to the repeated CADT009D message, to indicate
that those numbers are to be used.
BG // JOB DYNCAT INITIALIZE TAPES
DATE 01/22/00,CLOCK 19/51/53
BG // EXEC DYNCAT
BG CADC800D ENTER DYNCAT COMMAND
BG INTR 299
BG CADT009D VERIFY VOLUME NO=
BG 100732
BG CADT009D VERIFY VOLUME NO=100732
BG
BG CADC821I 299 100732 INITIALIZED
BG CADC800D ENTER DYNCAT COMMAND
BG INTR 29A
BG CADT009D VERIFY VOLUME NO=
BG 100733
BG CADT009D VERIFY VOLUME NO=100733
BG
BG CADC821I 29A 100733 INITIALIZED
BG CADC800D ENTER DYNCAT COMMAND
BG
BG READY FOR COMMUNICATIONS
BG
BG EOJ DYNCAT
DATE 01/22/00,CLOCK 19/53/08,DURATION 00/01/14
Initialization of scratch tape at OPEN time
A CADT008D MOUNT message is issued requesting a scratch tape. The
operator responds with the tape drive address, 299, which contains a labeled,
but non-CA Dynam/T controlled volume, number 100867. The operator enters
EOB/END to indicate that the existing number should be used.
BG CADT008D MOUNT SCRATCH TAPEOUT SYS011 DSN=AR TRANS
BG 299
BG CADT009D VERIFY NO=100867
BG
BG CADT007I **** LABEL TAPEOUT SYS011=299 100867 0001 *AR TRANS*
BG CADT031I *CLOSED* TAPEOUT SYS011=299 100867 AR TRANS BLK=12
2–4 User Guide