CA Dynam for VSE User Guide

Data Set Maintenance
Enter data specific to the generic group of data sets in the selection and
relation fields. Generic criteria is specified by entering an asterisk (*) as a
suffix to a root word (for example, enter ACC* in the Data Set selection
field to display all data sets in the Catalog whose names begin with ACC).
When you press Enter, a browse is initiated to search the CA Dynam
Catalog for any data sets that match the specified selection/relation
criteria. If found, any and all data sets that match are alphabetically
displayed on a directory panel. If no matching data sets are found, a blank
directory panel is displayed.
You can also select a group of generic data sets that end in a specific
character or combination of characters that have a specific character or
combination of characters imbedded within the data set name ('wild
cards'). To select all data sets ending in the characters PROD, enter
*PROD in the Data Set selection field. To select all data sets that have
PROD anywhere in the data set name, enter *PROD* in the Data Set
selection field.
• Display all the data sets in the CA Dynam Catalog.
Press Enter on this panel without specifying any selection or relation
criteria. All data sets in the CA Dynam Catalog are displayed.
Selection Field Descriptions
Data Set
Type
Disk Type
User ID
Owner ID
System ID
Specifies the specific or generic name of the desired data set(s).
Specifies the type of the data set.
Specifies the disk file type. SD, DA, and IS are valid entries.
Specifies the user ID associated with the data set.
Specifies the ownership code associated with the data set.
Specifies the system ID associated with the data set.
Relations
Enter either the relation's abbreviation or equivalent symbol:
Abbreviation Symbol Relation
EQ = Equal to the selection criteria.
NE ^= Not equal to the selection criteria.
LT < Less than the selection criteria.
GT > Greater than the selection criteria.
7–12 User Guide