CA Dynam for VSE User Guide

Catalog Support for CA Dynam/FI
Example
Analyzes a CKD disk file.
// JOB VCKDANAL ANALYZE A CKD DISK FILE
// DLBL CKDDISK,'CKD.FILE',2099/365,DA
// EXTENT SYS003,CKDDSK,1,0,19,10
// ASSGN SYS003,DISK,VOL=CKDDSK,SHR
// EXEC VCKDANAL
ANAL=3330
/*
/&
Catalog Support for CA Dynam/FI
Catalog File
The CA Dynam Catalog management facility lets you control the attributes of
tape and disk files. The Catalog file contains information about data set
attributes (block size, record length, and so on). This information is either
automatically or manually cataloged using the DYNCAT utility program or the
CUI FILE Management online screens. By using the utilities, you can define file
attributes separate from job control.
The same Catalog is shared by CA Dynam/D, /T, and /FI. The Catalog need
only be created once. The locations of the Catalog and Audit files are saved
when they are accessed for the first time following IPL. Only one file of each
type may be used in a particular system, and it must not be moved except
through the appropriate DYNCAT and AUDTUTIL functions, which cause the
saved location to be updated.
File attributes defined in the Catalog are used in addition to the options
defined in job control. CA Dynam/FI overrides the Catalog information with
definitions found on TLBL and DLBL statements.
Setting Catalog Support
There are two stages of catalog support for CA Dynam/FI:
• CATALOG(YES|NO) (set in the DYNAM/FI option record, for all data sets),
and
• DYNAMFI=YES|NO (set in the DYNCAT/CUI File Management utilities, for a
particular cataloged data set).
6–52 User Guide