CA Dynam for VSE User Guide

Using Other Software with CA Dynam/FI
Restrictions
As with any processing procedure that enhances system operation, there are
certain restrictions. In addition to the requirements specified above, the
following conditions must be met:
• All CA Dynam products (CA Dynam/D, CA Dynam/T and CA Dynam/FI)
must be installed and active on the system for the duration of the job.
• The program DTF type must be one that is supported by CA Dynam/FI.
• The file may not be the SORTOUT file of CA SORT.
• The NOFI operand must not be specified on the TLBL or DLBL statement.
If operator switching is requested and all of the above conditions are not met,
an appropriate message will be issued to the operator.
There are additional restrictions imposed by CA Dynam/D and CA Dynam/T.
For more information, see the chapters "Maintaining Tape Files" and "Disk File
Management."
Using Other Software with CA Dynam/FI
With CA Dynam/D and CA Dynam/T
If you use CA Dynam/D and CA Dynam/T products, you should be aware that
the Catalog file you currently access will be also be used by CA Dynam/FI. The
entire CA Dynam family uses the same Catalog file. The CUI File Management
transaction and DYNCAT utility programs are used to control and maintain the
CA Dynam/FI characteristics relating to tape and disk data sets; DYNACC, and
DYNPRINT can be used to access the FI information in the Catalog.
Defining Data Set Types
For control and allocation by CA Dynam/D and CA Dynam/T, data sets are
defined to the Catalog as the following:
• Tape data sets
• Disk data sets
• FI data sets
6–36 User Guide