CA Dynam for VSE User Guide

Controlling System Actions
// DLBL FISYSLS,'LISTING DISK',,SD,BLKSZ=1210
// EXTENT SYS001,111111,1,0,1,100
// ASSGN SYS001,DISK,VOL=111111
Change from printer output (DTFDI or DTFPR) to disk output. Any one of the
DLBL/EXTENT pairs will produce the same result: output will be to disk.
// DLBL FISYSLS,'TEST.FILE1',2099/365,,SYS008
// EXTENT SYS008,335000,1,0,1,10
/*
// DLBL FISYSLS,'TEST.FILE2',2099/365,,
// EXTENT SYS008,335000,1,0,1,10
/*
// DLBL FISYSLS,'TEST.FILE3',2099/365,,SYS008
// EXTENT ,335000,1,0,1,10
Controlling System Actions
Setting System Controls - SET Statement
CA Dynam/FI gets certain unique SET statements from either SYSLOG or
SYSRDR in order to temporarily or permanently (until next IPL) alter system
actions. For more information about the standard syntax notation used, see
the chapter "Introduction."
SET Format
The format for SET is shown below.
[//] SET CPCMD='command'
[//] SET DYNAMFI= {ON|OFF }
[//] SET $JOBEXIT= {AFTER|BEFORE }
[//] SET [PARTID= {xx|* }] [,AUDIT= {ON|OFF } ]
[,EXECSIZE= {nnn|(nnn,AUTO)|(nnn,MAX) } ]
[,FIPROG= {ON|OFF } ]
[,SEARCH=(NOUR|UR,NODI|DI,NOCP|CP) ]
[,SORTCORE=nnnnnn ]
The defaults for the preceding operands are specified in the DYNAM/FI option
record.
CPCMD=
Lets you pass a command to CP while running under VM.
6–26 User Guide