CA Dynam for VSE User Guide

TLBL/DLBL Extensions
file-id
1—44 alphanumeric characters enclosed in single quotes. Equals data set
name in CA Dynam Catalog.
File-id can contain the following extensions:
• CA Dynam/D disk processing option codes, separated by commas with no
intervening blanks and enclosed in parentheses (or beginning and ending
symbols as defined in the DDOPTS option record).
Example
// DLBL SDDOUT,'DISK.FILE(A,I)'
• File-id length, including option codes, cannot be greater than 59.
A
B
C
D
D1
E
F
Align on cylinder boundary
Bypass AVR and DASD device independence
Catalog data set
Delete file from VTOC at input close
Do diagnostic trace of CA Dynam processing
Enqueue file opened for input, update or output
Fragment space allocation
G= Access this absolute generation number
G# Access this generation number
G- Access this relative generation number
I
IE
K
L
M
N
NA
NF
O
P
S
S:nnn
T
W
Send messages to SYSLST
ISAM extend
Keep SD file after close
Lock file for read-only usage
Send messages to SYSLOG
Do not truncate at close
No automatic secondary allocation
Do not fragment
Access existing file; do not reallocate
Prohibit dynamic LUB allocation
Use same space for SORTIN/SORTOUT
Override with this SYS number
Truncate ISAM extent or SD work file
Delete SORTWK file at close
Chapter 1: Introduction 1–13